Damp, Mould and Condensation
Your household should have a home that is safe, warm and comfortable, this is a home without mould growth that comes as a result of excess condensation and damp. All homes are at risk of condensation, especially during the colder winter months, moisture in the air is natural.
If you report excess condensation, damp or mould growth we will then organise an inspection to identify the cause of the issues you are experiencing and work together to ensure any risks, hazards or problems are resolved as a priority. The treatment to remove any mould growth is critical, keeping the home free of it going forward is our priority for our residents.
Report damp or mould
Types of Damp
There are a number of types of damp and the causes for them can be completely individual to your home.
Penetrating damp
Penetrating damp is caused by water seeping through walls from outside from structural problems such as full guttering with moss or leaves build up causing them to overflow, or faulty guttering seals. A cracked downpipe could be directing rainfall onto the brick work, and this would present itself as a concentrated damp patch on the walls or ceilings inside the home with a clear edge. The issue may get worse when it rains depending on the cause and will lead to persistent mould growth unless the cause is resolved.
Rising damp
This type is cause by moisture in the soil or foundations moving up through a wall and will only affect ground floor rooms. It isn’t very common and is usually prevented by a barrier called a damp proof course. Rising damp can occur if the damp proof course in your home is either missing, damaged or being bridged (a common issue is if the soil level is above the damp proof course). The signs internally are damaged / swollen skirting board, peeling paint or wall paper, also in some cases a visible tide mark along the bottom of the wall.
Traumatic damp
A wet looking patch or area in a home caused by:
- A burst water supply pipe;
- Overflowing sinks or baths;
- Leaking radiator;
- Defective water storage tank;
- Leaks from a neighbouring home; and
- Environmental flooding.
What is Mould?
Black mould can grow on any surface of a home, providing conditions are suitable but common places including window panes, windowsills, corners of a room on the ceiling or walls. If you notice mould forming, it’s important that it’s removed and treated straightaway. Prolonged exposure can trigger allergic reactions, cause persistent coughing and worsen an asthmatic condition.
What is Condensation?
Condensation occurs when excess moisture in the air meets a cold surface such as a window pane, and turns into water droplets. Everyday activities like cooking, cleaning, bathing or showering and breathing produces the excess moisture.
Condensation is more likely to occur in winter due to colder surfaces, moist warm air in the home and reduced ventilation.
Small amounts of steam on a bathroom window is not a concern but a large amount on the inside of your windows in the morning needs to be dried with a dry, clean cloth or kitchen towel.
First Steps Against Mould Growth
First treat the mould already in your home, then deal with the basic problem of condensation to stop mould reappearing. To kill and remove mould, wipe down or spray walls and window frames with a fungicidal wash that carries a Health and Safety Executive (HSE) ‘approval number’, and ensure that you follow the instructions for its safe use. Make sure that the washes and sprays carry the HSE approved number as some contain bleach that can feed the mould further.
These fungicidal washes are often available at local supermarkets. Dry clean mildewed clothes, and shampoo carpets. Do not try to remove mould by using a brush or vacuum cleaner. After treatment, redecorate using good-quality fungicidal paint and fungicidal resistant wall paper paste to help prevent mould recurring. The effect of fungicidal or anti-condensation paint is destroyed if covered with ordinary paint or wallpaper.